Fluke-DH-Instruments E-DWT Calibrations and Repair

Home → Calibration Service → Pressure Calibration → Fluke-DH-Instruments-Calibrations → Fluke-DH-Instruments E-DWT Calibrations and Repair

Have your Fluke-DH-Instruments calibration equipment calibrated in the ISO/IEC 17025 accredited lab!

Minerva is specialized in repair and calibration services of Fluke-DH- Instruments equipment. These Fluke-DH-Instruments are calibrated in a ISO/IEC 17025 accredited calibration lab.

The calibration is performed by calibration technicians. We have many years of experience in calibrating Fluke-DH-Instruments equipment. In short, your Fluke-DH-Instrument equipment is taken good care off!

We focus on a reliable lead time and high standard of our service.

Fluke-DH-Instruments E-DWT Electronic Deadweight Tester

No weights to load and unload or regularly send out for calibration
No need to know and correct for local gravity or ambient temperature
No piston-cylinder changes; switch Q-RPT ranges in seconds
Not sensitive to level or vibration
Able to set and read any pressure value exactly, no minimum increment limited by smallest available masses
Operates in any unit of measure while deadweight tester is typically limited to the pressure unit stamped on the mass
Perfect for applications that require setting a nominal pressure precisely on the device under test and measuring it, such as analog gauge calibration
On-board, AutoTest calibration routines and data acquisition
Interfaceable with a PC or laptop to allow for automated data acquisition
Two year calibration interval supported at measurement uncertainty of ± 0.025% of reading.
Easily recalibrated without crossfloating. Automated calibration of E-DWT-H is possible using COMPASS® for Pressure software.

Have your Fluke-DH-Instruments E-DWT serviced at Minerva!