Ametek HL-10 Calibrations and Repair
Have your Ametek calibration equipment calibrated in the ISO/IEC 17025 accredited lab!
Minerva is specialized in repair and calibration services of Ametek instruments. These Ametek instruments are calibrated in a ISO/IEC 17025 accredited calibration lab.
The calibration is performed by calibration technicians. We have many years of experience in calibrating Ametek instruments. In short, your Ametek instrument is taken good care off!
We focus on a reliable lead time and high standard of our service.
Ametek HL-10 Deadweight tester
Ametek HL serie deadweight tester
The HydraLite Tester is a primary standard available as a dead weight tester or a gauge. Both feature a re-entrant type measuring piston and cylinder assembly. This design reduces the rate of fluid leakage and increases float time, helping to maintain accuracy as test pressures increase. Each tester features an easy-to-use, convenient screw pump as the pressure source, which contains a ratchet feature that prevents the unit from depressurizing unexpectedly.
• Accuracy to 0.05% of reading
• Ranges to 3000 psi
• Available in psi, kg/cm², bar, and kPa
• Dual piston models extend the range of single weight sets
Designed for lab or field use, each tester is completely self-contained within the cover of the unit.
• Overhung weight carrier reduces side thrust and friction
• Quick-leveling system for field use
• Optional Tripod
• Over-pressure protection prevents piston damage
Have your Ametek HL-10 serviced at Minerva!
